Leaderboard

The movement with the 3d printed train is pretty cool though. I guess it at least has that going for it.

Here around the 2:10 timestamp is a good look at the 3D printed tiny train and its functions. This would mark the first widely available set to include such an element while technically being LEGO's fourth official 3D printed piece I believe. 1st was a drafting table machine arm from a LEGO Tour 2019 set (New Elementary article with actual photos), 2nd a toy duck given as a gift with purchase to LEGO House visitors, third a pogo stick for backers of The Secret Life of LEGO book, and now this toy train. After looking back at how incredibly niche & rather sparse the releases of 3D printed elements LEGO has attempted thus far, I am not too worried of its inclusion here. I do ponder upon what this may entail going forward of course.

It took 13 years and I just had my first casualty to the "brittle brown" epidemic of 2012-2017. Poor Bard the Bowman. I was organizing my minifigures, nudged his right leg, and it snapped right off going flying. I managed to save his legs, main torso, head, hair, & hands. However, the arms and waistline piece are dust in the wind. I took a handheld power drill with the smallest drill bit I had and slowly ground down the peg extending from the hip's middle part (circular disk area between the legs, the "groin" I suppose) into the leg piece itself still stuck until said peg crumbled. (Repeated for the other leg because that snapped off too.) I decided to drill out the stiff arms as well instead of waiting for either of those to do the same as what the legs did and/or crack the torso. There is a little bump at the end of the arm piece resting inside the torso, I started with drilling that bit down until it fell apart which loosened the rest of the arm to pop off mostly. The external section of the arm broke off while leaving some "armpit" in the hole. Once again, carefully drilled until that crumbled. Walked away with a couple abrasions on the inside of the legs facing the "groin" area (of which only really show up under a light) and no cracks on the torso anywhere. Not sure what to do next. I may very lightly smooth down the inner surface area of the legs and arms to reduce any possible grinding should I replace the hip & arm parts. Ol' Bard will be missing his hip printing and have little in the way of pose ability but compared to the worst-case scenario, I think he will be alright. Well, mostly. ....And now onto my army of fourteen Uruk-Hai. Nothing broken or cracked there, only stiff thank goodness. I just have a bunch of bodies missing their heads & hands in a drawer. ....Well, that last sentence sounded wrong. Anywho. I was thinking of picking up some plain dark red torsos from LEGO's pick a brick (if they ever get any in that is) or use some other dark red torsos. I mean, the Uruk-Hai minifigures are going to be wearing chest armor therefore any printing will simply be covered anyhow. Not sure about the legs; perhaps something dark brown. At the moment I am using a couple of the Hun Warrior minifigure as a new body. (Dark red torso with nice leggings that actually kind of work for the ork.) I am curious what other leg prints could work. So that's what I have been up to. General organizing, building some armies, and.... stuff.