After seeing a post on The Brother's Brick, I got inspired and decided to create my own small scale THE LEGO MOVIE logo.

Because of my lack of pieces, I had to construct a cube and build the words over it.  I know that grey is not the ideal color, but that is what I had.  I still want to buy some pieces on Pick-A-Brick to finish off the texture on the front.

Here's the back:

Comments, criticisms, and suggestions welcome!

The **** stuck to the E rather spoils it and the grey lego makes it look dusty. It looks nothing like the one on brothers brick, so close to being quite good though.

If you look at the one on brother brick, "the" actually covers "lego" you need an 8 x 10 plate, im not sure lego do them so try a 6 x 10 and a 2 x 10... instead of the 8 x 8 "the" is on.

I have a sack of black plates, I'd send you them for free but postage to the states cost too much.

If you look at the one on brother brick, "the" actually covers "lego" you need an 8 x 10 plate, im not sure lego do them so try a 6 x 10 and a 2 x 10... instead of the 8 x 8 "the" is on.

Thanks for the suggestion.  I'll try that.

Grey looks just fine great job

After much contemplation on how to make "T" "****," and "E" "unstuck," I decided to put a 1X8 plate at the top followed by a 1X10 and a 4X10. After that, I put a 2X6 and a 2X2 to make a 2X8 at the bottom. If that did not make sense, here's the picture:

 

 

 

And here's a picture of the whole thing: